Current issue
Online first
Archive
About the Journal
Aims and scope
Publisher and Editorial
Advertising policy
For Authors
Paper review procedures
Procedures protecting authentic authorship of papers
Paper preparation manual
Plagiarism check
Publication ethics
Reviewers
APC
Editorial and Scientific Board
Contact
Reviewers
Topic Exhaust emissions
The analysis of the operating conditions of a heavy-duty engine of a vehicle designated for timber transport in terms of compliance with the RDE procedures
Combustion Engines 2024,199(4), 140-150
Correlation relationships of processes in the combustion engine in the RDE test
Combustion Engines 2024,199(4), 112-125
Vehicle related non exhaust particle emissions – Euro 7 requirements
Combustion Engines 2024,199(4), 15-29
Adopted LTO cycle to operational conditions at polish airports
Combustion Engines 2024,199(4), 67-73
The criteria for qualifying fuels as a replacement fuels for internal combustion engines
Combustion Engines 2024,199(4), 60-66
The use of dimethyl ether (DME) solution in compression ignition engine
Combustion Engines 2024,198(3), 123-128
Comparative analysis of waste-derived pyrolytic fuels applied in a contemporary compression ignition engine
Combustion Engines 2024,198(3), 74-81
Exhaust emissions from a jet engine powered by sustainable aviation fuel calculated at various cruising altitudes
Combustion Engines 2024,198(3), 62-67
Properties of substitute motor fuels produced from ethanol in biorefineries
Combustion Engines 2024,198(3), 41-47
Evaluation of the effects of the application of Ti−C:H DLC coatings obtained by PVD techniques in the kinematic pairs of internal combustion engines and powertrain systems.
Combustion Engines 2024,198(3), 27-33
Simulation studies of pollutant emissions from road vehicles using models for inventories of pollutant emissions
Combustion Engines 2024,198(3), 20-26
Dual-fuel engines using hydrogen-enriched fuels as an ecological source of energy for transport, industry and power engineering
Combustion Engines 2024,198(3), 3-12
Analysis of harmful compounds concentrations in the exhaust behind a vehicle with compression ignition engine
Combustion Engines 2024,197(2), 50-55
Study of the effect of ignition crank angle and mixture composition on the performance of a spark-ignition engine fueled with ethanol
Combustion Engines 2024,197(2), 56-63
Efficiency optimization of a vehicle combustion engine by the adjustment of the spark advance angle
Combustion Engines 2024,196(1), 10-14
Comparison of exhaust emission results obtained from Portable Emissions Measurement System (PEMS) and a laboratory system
Combustion Engines 2023,195(4), 128-135
Research and analysis of the operation of vehicles with various propulsion systems, including costs and CO2 emissions
Combustion Engines 2023,195(4), 3-13
Selected vehicle emissivity assessment issues in passenger transport services
Combustion Engines 2023,195(4), 14-22
Modeling the dynamics of changes in CO2 emissions from Polish road transport in the context of COVID-19 and decarbonization requirements
Combustion Engines 2023,195(4), 63-70
Evaluation of the impact of supplying a marine diesel engine with a mixture of diesel oil and n-butanol on its efficiency and emission of toxic compounds
Combustion Engines 2023,195(4), 40-47
Effect of DMC blend ratio on emission characteristics for diesel engine generator fueled with DMC/diesel blended fuel
Combustion Engines 2023,195(4), 23-27
Technology for manufacturing catalytic systems using a pilot line for precious metal recovery
Paweł Fuć, Barbara Sokolnicka-Popis, Andrzej Ziółkowski, Maciej Bednarek, Aleks Jagielski, Anna Michałowska
Combustion Engines 2023,194(3), 89-96
Improving the performance of diesel engines fueled with water-fuel emulsion
Combustion Engines 2023,194(3), 116-122
Evaluation of pollutant emissions from a railbus in real operating conditions during transport work
Combustion Engines 2023,194(3), 84-88
Comparison of operational parameters and stability of performance of an automotive SI engine powered by methyl and ethyl alcohols
Combustion Engines 2023,194(3), 129-140
Investigation of processes in the WLTC test of a passenger car with a diesel engine
Combustion Engines 2023,194(3), 52-62
Minimizing indoor infection risks with automotive nanofiltration and with laminar vertical flow
Jan Czerwiński, Andreas Mayer, Jörg Mayer, Heinz Burtscher, Thomas Lutz, Rainer Mayer, Barbara Rothen-Rutishauser, Joachim Frey, Christian Lämmle, Tobias Rüggeberg, Patrick Specht
Combustion Engines 2023,194(3), 68-77
Analysis of the combustion engine exhaust system structure in aspect of shaping acoustic energy
Combustion Engines 2023,193(2), 112-116
Numerical evaluation of urea-mixing devices for close-coupled selective catalytic reduction systems
Combustion Engines 2023,193(2), 84-93
Research of pollutant emissions from automotive internal combustion engines in conditions corresponding to the actual use of vehicles
Combustion Engines 2023,193(2), 64-70
Assessment of the life cycle of city buses with diesel and electric drive in the operation phase
Combustion Engines 2023,193(2), 117-121
Empirical study of the effect of the air filter on the performance and exhaust emissions of a diesel engine
Combustion Engines 2023,193(2), 94-111
Assessment of two condensation particle counters (CPCs) in photometric mode for high concentration exhaust emission measurements
Combustion Engines 2023,193(2), 15-23
Analysis of the performance of an aircraft powered by hybrid propulsion
Combustion Engines 2023,193(2), 45-51
Comparative analysis of the heat balance results of the selected Tier III-compliant gas-fuelled two-stroke main engines
Combustion Engines 2023,193(2), 24-28
Analysis of jatropha oil-kerosene fuel mixtures on the performance of a variable-load direct injection CI engine
Combustion Engines 2023,192(1), 11-18
Numerical study of internal flue gas recirculation system applied to methane-hydrogen powered gas microturbine combustor
Combustion Engines 2023,192(1), 63-77
The material and economic assessment of the life cycle of city buses in the operational phase
Combustion Engines 2023,192(1), 50-54
Effect of deposition of carbon deposits on charge flow in EGR valve in CI engine
Combustion Engines 2023,192(1), 26-35
Numerical optimization of the BAT-CELL Bio-Ambient-Tests method for engine exhausts toxicity evaluation
Combustion Engines 2023,192(1), 19-25
Comparative analysis of the life-cycle emissions of carbon dioxide emitted by battery electric vehicles using various energy mixes and vehicles with ICE
Combustion Engines 2023,192(1), 3-10
Determination of characteristics of pollutant emission from a vehicle engine under traffic conditions in the engine test
Combustion Engines 2022,191(4), 58-65
Assessment of retrofit devices for the Horizon 2020 Cleanest Engine and Vehicle Retrofit Prizes
Combustion Engines 2022,190(3), 27-34
Ammonia CI engine aftertreatment systems design and flow simulation
Combustion Engines 2022,190(3), 3-10
Environmental analysis of the traffic closure on Piotrowo and Berdychowo streets in Poznań
Combustion Engines 2022,190(3), 18-22
Impact of the use of comfort devices on the exhaust toxic compounds from a modern PC car with spark ignition engine
Combustion Engines 2022,190(3), 50-55
Methodology of diesel particulate filter testing on test bed for non-road engine application
Combustion Engines 2022,190(3), 72-79
Method of verifying the emission level of the exhaust components of a special vehicle in relation to EURO III standard in road conditions
Combustion Engines 2022,189(2), 89-93
The tests of micro-CHP prototype with SI engine powered by LPG and natural gas
Combustion Engines 2022,189(2), 47-53
Effect of driving resistances on energy demand and exhaust emission in motor vehicles
Combustion Engines 2022,189(2), 60-67
Calibration of micro-simulation model in assessment of passenger car exhaust emission during acceleration
Combustion Engines 2022,189(2), 54-59
Analysis of emissions and fuel consumption from forklifts by location of operation
Combustion Engines 2022,189(2), 30-35
Effect of compression ignition engine preheating on its performance under cold start conditions
Combustion Engines 2022,188(1), 67-74
Modelling of the air pollutants’ cold-start emissions depending on average vehicles’ speed
Combustion Engines 2022,188(1), 96-103
Research of ecological indicators of two-way vehicle in stationary conditions
Combustion Engines 2022,188(1), 30-34
Analysis of the market structure of long-distance transport vehicles in the context of retrofitting diesel engines with modern dual-fuel systems.
Combustion Engines 2022,188(1), 13-17
Experimental investigation of biodiesel-n-butanol fuels blends on performance and emissions in a diesel engine
Combustion Engines 2022,188(1), 90-95
Application of automotive safety design methodologies to the development of Euro 7 emission control systems including on board monitoring.
Combustion Engines 2022,188(1), 75-82
The concept of a maintenance-free drive-thru inspection station for commercial vehicles
Combustion Engines 2022,188(1), 35-41
The emission of harmful compounds from the marine diesel engine fueled by a blend of n-butanol and marine fuel
Combustion Engines 2021,187(4), 90-95
Analysis of pollutant emissions and fuel consumption for the use of a multi-storey carpark
Combustion Engines 2021,187(4), 46-51
Comparative analysis of the emissions of carbon dioxide and toxic substances emitted by vehicles with ICE compared to the equivalent emissions of BEV
Combustion Engines 2021,187(4), 102-105
Numerical investigation of the internal flue gas recirculation system applied to methane powered gas microturbine combustor
Combustion Engines 2021,187(4), 21-29
Use of toxicity indicators related to CO2 emissions in the ecological assessment of an two-wheel vehicle
Combustion Engines 2021,187(4), 36-41
A conceptual design and numerical analysis of the mixerless urea-SCR system
Combustion Engines 2021,187(4), 12-20
The future of road transport in Europe. Environmental implications of automated, connected and low-carbon mobility
Combustion Engines 2021,186(3), 3-10
Numerical analysis of the flow rig for UWS spray examination in exhaust system-relevant conditions
Combustion Engines 2021,186(3), 103-112
Effect of nitrON® cetane-detergent additive to B7 fuel on energy parameters and exhaust gas composition of a 6Dg locomotive with a Caterpillar C27 engine
Combustion Engines 2021,186(3), 51-58
Experimental determination of compressor map of the DGEN 380 engine compressor using the WESTT CS/BV turbine engine simulator
Combustion Engines 2021,185(2), 26-31
Emissions of a Euro 5 Motorcycle over the world harmonized motorcycle test cycle (WMTC)
Combustion Engines 2021,185(2), 21-25
Emissions of reactive nitrogen compounds (RNCs) from two vehicles with turbo-charged spark ignition engines over cold start driving cycles
Combustion Engines 2021,185(2), 3-9
Comparative study of combustion and emissions of diesel engine fuelled with FAME and HVO
Combustion Engines 2021,184(1), 72-78
Influences of special driving situations on emissions of passenger cars
Combustion Engines 2021,184(1), 41-51
The influence of the heating time of a catalyst-covered glow plug on the exhaust emissions from a diesel engine
Combustion Engines 2021,184(1), 52-56
Ecological comparative assessment of selected materials used for the construction of spark ignition engines
Combustion Engines 2020,183(4), 11-14
Overview of low emission combustors of aircraft turbine drive units
Combustion Engines 2020,183(4), 45-49
The impact of particulate filter substrate type on the gaseous exhaust components emission
Combustion Engines 2020,183(4), 58-62
An internal combustion engine without a crankshaft. Perspectives.
Combustion Engines 2020,183(4), 39-44
Non-Regulated Emissions and PN of Two Passenger Cars with Diesel-Butanol Blends
Combustion Engines 2020,183(4), 29-38
Analysis of exhaust emission measurements in rural conditions from heavy-duty vehicle
Andrzej Ziółkowski, Paweł Fuć, Piotr Lijewski, Łukasz Rymaniak, Paweł Daszkiewicz, Michalina Kamińska, Natalia Szymlet, Aleks Jagielski
Combustion Engines 2020,182(3), 54-58
Evaluation of the significance of the effect of the active cross-sectional area of the inlet air channel on the specific enthalpy of the exhaust gas of a diesel engine using statistics F of the Fisher-Snedecor distribution
Combustion Engines 2020,182(3), 10-15
Cold start emissions from a gasoline engine in RDE tests at different ambient temperatures
Combustion Engines 2020,181(2), 24-30
By-products from thermal processing of rubber waste as fuel for the internal combustion piston engine
Combustion Engines 2020,181(2), 11-18
The impact of parameter modifications in the Diesel engine power system on the emissions of harmful compounds
Combustion Engines 2020,180(1), 36-40
Hydrocarbon species in SI and HCCI engine using winter grade commercial gasoline
Combustion Engines 2020,180(1), 17-24
Overview of the light-duty vehicles tailpipe emissions regulations in the European Union: status and upcoming type-approval and market surveillance schema
Combustion Engines 2020,180(1), 3-7
Sign up for email alerts
Most read
Most cited
| eISSN: | 2658-1442 |
| ISSN: | 2300-9896 |
The scientific journal is financed under the Agreement 185/WCN/2019/1 from the funds of the Minister of Science and Higher Education
© 2006-2025 Journal hosting platform by Bentus
We process personal data collected when visiting the website. The function of obtaining information about users and their behavior is carried out by voluntarily entered information in forms and saving cookies in end devices. Data, including cookies, are used to provide services, improve the user experience and to analyze the traffic in accordance with the Privacy policy. Data are also collected and processed by Google Analytics tool (more).
You can change cookies settings in your browser. Restricted use of cookies in the browser configuration may affect some functionalities of the website.
You can change cookies settings in your browser. Restricted use of cookies in the browser configuration may affect some functionalities of the website.
